A Chrome Molybdenum pipe bender for making tidy bends in brake pipes. ...

A 1/2" drive, 20 piece, Deep, impact socket set. ...

The Laser 6831 is required to install the crankshaft position Sensor Ring on Discovery 3/4, Range Rover Sport when fitted with TDV6 engine (3 Powertrain). This tool is also designed to be used with Jaguar models including installing the trigger wheel to the rear crankshaft on the X200 S Type, X250 XF, X350 XJ & X351 XJ (300 powertrain). Completing this tool is a robust build for added reliability. ...

This Laser socket is manufactured from Chrome Vanadium & is part of the Laser range of Air Impact Sockets in 1/2"D. ...

Power tool adaptor 2 in 1 takes 1/4" Drive bits & 1/4" Drive sockets
- 75mm long 2 in 1 Adaptor. ...

This kit from Laser Tools means that you can remove damaged hex cap Bolts & screws. ...

The Laser rear swinging arm bush remover/installer tool kit for post 2008 MK6 Ford Fiesta is for use on the vehicle therefore reducing time taken to replace the bush. Designed to be used on car with the minimal strip down reducing the time taken to replace worn bushes. This handy product is completed with a reliable manufacture in Sheffield. ...

Flameless hot air blower for use with all heatshrink tubes temp up to 650°C. Features electronic ignition/refillable tank with see through window/variable heat control ...

The Laser 6849 fuel pump drive belt kit has been designed for locking the fuel pump into its timed position, so that the pump drive belt can be replaced, or the pump timing checked. This model is ideal to be used with vehicles & engines codes: Audi A4 2007-2012, A5 2007-2012, A6 2008-2011, Q52008-2012, Q7 2007-2012 Volkswagen: Phaeton 2007-2015, Touareg 2007-2011 plus Porsche Cayenne 2008-2016 2.7 CAMA, CAMB, CGKA, CGKB, CANA, CANB, CANC, CAND 3.0: CCWB, CCWA, CCLA, CDYA, CDYB, CDYC, CASA, CASB, CCMA, CAS. M05/9E, M05/9D (CAS), CARA, CEXA, CEXB, CASC, CATA, CASD This unit is completed with a reliable manufacture in Sheffield. ...

The SAC clutch mandrel kit for centering the clutch disc on the flywheel, while installing self adjusting clutch suitable for BMW vehicles. This tool can also be used to align new & previously pre-tensioned SAC clutches & contains

Sizes: 15mm x 23mm, 15mm x 26.5mm, 15mm x 28mm, 15mm x 32.5mm, 15mm x 34mm. This kit is completed in a blow mould case for easy storage.

...