A security hex bit for use on tamper proof hex fittings 2mm to 14mm ...

Battery terminal ratchet wrench with twin head 8 x 10mm 72 teeth. ...

Go Thru' angled socket wrench in metric sizes, manufactured from CV6140 steel. Sizes 6-13 mm 6 & 12 point. The Go-thru function makes it absolutely ideal to be used with long threaded rods. ...

In your busy workshop there are countless ways for threads to get damaged: knocking a track rod end with a hammer; cutting a bolt or threaded rod to length; driving a driveshaft out of a hub — the threaded ends get torn & squashed. Wheel studs get damaged just by removing & refitting the wheels… Luckily there is a quick & easy solution from Laser Tools: the external deburr & chamfer tool! The chamfer tool is designed to be used with an electric drill & is fitted with a 1/4" quick-chuck shaft, maximum recommended speed is 400rpm. The tool is fitted with three super-hard High Speed Steel blades that make light work of repairing damaged bolts & damaged threads. The blades cut quickly & cleanly & are effective on stainless steel, hardened steel, mild steel, copper, brass, wood, fibreglass, & even hard plastic. Bolts, studs & threaded rod, size range from 3mm right up to 19mm. Hammer-damage or squashed & flattened threads will stop the retaining nut or wheel nut screwing back on; a couple of zaps from the deburr/chamfer tool solves the problem instantly. Cutting steel or copper pipe can leave an uneven edge that can stop an olive or tube nut being slid on. A gentle touch with the tool leaves a nicely chamfered edge, & the olive slides straight on. ...

The 7511 Flywheel Locking Tool is a Laser Tools EU registered design. Unique in its design & simplicity, this tool is designed to allow the user to quickly & simply lock the flywheel via the ring gear when removing the clutch, flywheel or front pulleys during engine strip down or clutch replacement. It can also be used to lock the ring gear when checking the dual mass flywheel play. ...

Japanese Industrial Standard screwdriver kit – T-Handle with 6 magnetic bits. For use on Japanese industrial standard screws fitted to classic Japanese motorcycles / cars / bicycles / equipment. The use of the correct bit helps prevent cam out & damage to the JIS fixing. ...

A universal Stretchy Belt Removal/ Fitting Tool which is ideal for fitting & removing stretch belts on a wide range of vehicles & machinery. ...

This kit is made up of a set of 12 cleverly designed hexagon bolt & nut extractor adaptor caps. The caps fit over the rounded off fixing & allow a standard 12 point socket or ring wrench to be used to remove the rounded off hexagon fitting. 8mm – 19mm sizes. Due to material used, these tools should be considered consumable. Following the instructions for use will help significantly increase the service life of the kit ...

This magnetic bit organiser takes 43 different bits & adaptors it is specifically designed for 10mm shank automotive bits ...

A 160 piece non insulated terminal & Anderson plug repair tool kit ...